Table of Contents
Dimensional details
This page gives the dimensional details of the Green Drive ISO tubular linear motors. The dimensions are needed for the machine design, the mounting, and the selection of the correct stroke.
GDI250 Dimensions
| MOTOR | STATOR LENGTH Lm | MF threaded hole | Diameter D | SLIDER LENGTH Ls | UNIT |
| GDI250T | 198 | M8x10 | 25 | Stroke + 198 + terminals | mm |
| GDI250Q | 230 | M8x10 | 25 | Stroke + 230 + terminals | mm |
| GDI250X | 374 | M8x10 | 25 | Stroke + 374 + terminals | mm |
GDI350 Dimensions
| MOTOR | STATOR LENGTH Lm | MF threaded hole | Diameter D | SLIDER LENGTH Ls | UNIT |
| GDI350TS | 208 | M10x16 | 35 | Stroke + 208 + terminals | mm |
| GDI350XS | 358 | M10x16 | 35 | Stroke + 358 + terminals | mm |
| GDI350ES | 484 | M10x16 | 35 | Stroke + 484 + terminals | mm |
Reading the dimension table
- Stator length Lm is the length of the fixed stator. - MF threaded hole is the fixing thread on the stator flange. - Diameter D is the slider rod diameter. - Slider length Ls depends on the stroke: it is the stroke plus the stator length plus the terminal allowance. - Use these values together with the mounting page and the 3D models to design the machine frame.