Table of Contents
How to use connectors
How to use speedtec connector
The standard connection system based on speedtec connector on the cable must be used with the right alignment before pushing it inside the connector on the motor side. Please use the marker on the two connectors to avoid permanent damage to the inside parts of the connector on the motor side. (see photo below)
Power Side
Signal Side
IF THE ALIGNMENT IS WRONG AND IF YOU FORCE THE CONNECTOR IN, YOU WILL DAMAGE
THE INTERNAL PIN HOLDER AND THE ENCODER FEEDBACK WILL STOP TO HAVE A CONNECTION TO THE DRIVE !!!!
How to see if the insert is damaged or not
 |  |
| DAMAGED INSERT IS NOT ALIGNED WITH THE CONNECTOR FRONT SIDE | NOT DAMAGED INSERT IS ALIGNED: ALL THE PINS ARE ALIGNED WITH THE FRONT SIDE |