Table of Contents
Programming software
This page describes the programming software for the Motolab actuator. The integrated motor drive is configured with the PC software.
In order to configure the integrated motor drive, please use the PC software called Motolab Starter: https://www.nilab.at/download/motolab_starter_ver0-0-1-0/?wpdmdl=6631&refresh=635638e9ee1601666595049
What Motolab Starter is used for
- Parameter configuration and commissioning of the integrated drive. - Setup and test of the motion profiles and the homing sequences. - Real-time monitoring of the drive status and the actuator position. - Diagnostics and fault analysis during commissioning.
How to proceed
- Download and install the Motolab Starter software. - Connect the drive to the PC with the programming cable. - Configure the motor parameters and the motion settings. - Save the configuration and verify the actuator operation.