Fulltext results:
- Protection
- operly before switching the equipment on. Prevent contact with live parts at any time. \\ * A residual-curr... CD) must not be used on electric drives! Indirect contact must be prevented by other means, for example, by... lth hazards will occur.| ==== Protection against contact with hot parts ==== |{{:integrated_drive_motors:
- Digital Signals @mbd_servo_drive
- dicated output, called relay Ok, provides a clean contact. In the start sequences you have to take account of the Relay OK contact.\\ After the auxiliary power supply +24 V to pin ... there aren't abnormalities the C5/11-12 Relay OK contact is closed allowing the system controller to provi
- Service and support
- ===== Service and support ===== ==== Info for contact ==== For any kind of technical questions please contact: **NiLAB GmbH** \\ Hans-Sachs-Straße 16\\ 9020 K
- Electrical connection @ironcore_motors
- matic, please check the relevant documentation or contact the manufacturer.\\ The cable outlet is configura... ies_1.jpg?nolink&600x249|l_series_1.jpg}} Please contact us to have the corresponding cable diameter in re
- Installation @mbd_servo_drive
- ody before touching the servo amplifier and avoid contact with highly insulating materials (plastic materia... is necessary to protect the user from accidental contact.\\ The electrical contacts of the servo amplifier
- Glossary
- r movement. A brushed motor relies upon brush/bar contact to switch the windings mechanically. A brushless
- Safety instruction
- t have the user documentation for your equipment, contact a NiLAB representative to send this documentation
- BISS-C Encoder interface @green_drive_iso
- ====== BISS-C Encoder interface ====== Please contact NiLAB to buy the programming cable and software to c
- IP protection and Cooling @green_drive_iso
- e number defines the degree of protection against contact and penetration of foreign particles. The second
- IP69K ISO Version @green_drive_iso
- * Hardness: 500-600 HV * Suitable for direct contact with food Therefore, aluminium alloys with the G
- BISS-C Encoder interface @green_drive_motors
- ====== BISS-C Encoder interface ====== Please contact NiLAB to buy the programming cable and software to c
- IP protection and Cooling @green_drive_motors
- e number defines the degree of protection against contact and penetration of foreign particles. The second
- Maintenance @integrated_drive_motors
- se parameters (for example the peak current) must contact NiLAB to have the instruction and the pass code.
- Installation tolerances @ironcore_motors
- ation of the specified performance data,\\ • to a contact between the primary and the secondary and thus to
- Motor cooling @ironcore_motors
- built-in motor protection thermal switches (break contact) being located in end windings and reacting at th