meta data for this page
Ports
This page shows the ports of the EtherCAT gateway. The connector layout and the pin assignments are shown for the lower and upper side.
Lower-side
C1 Connector
| Pin | Description |
| 1 | 24VDC |
| 2 | GND |
| 3 | 24VDC |
| 4 | GND |
ETH0 - PORT IN / ETH1 - PORT OUT
Upper-side
C2 Connector - DSUB9 Male
| Pin | Description |
| 1 | DIG_IN1 |
| 2 | CAN_L |
| 3 | GND |
| 4 | DIG_OUT1 |
| 5 | DIG_OUT2 |
| 6 | DIG_IN2 |
| 7 | CAN_H |
| 8 | DIG_IN3 |
| 9 | DIG_OUT3 |
C3 MODBUS and Serial COM
| Pin | Description |
| 1 | MODBUS B |
| 2 | MODBUS A |
| 3 | – |
| 4 | – |
Please use the USB to UART3V3 cable to connect the gateway to the configuration software.
Notes
- C1 provides the 24 VDC power supply. - ETH0 is the EtherCAT port in; ETH1 is the port out (daisy-chain). - C2 (DSUB9 male) provides the digital I/O and the CAN bus. - C3 provides the MODBUS and the serial COM for the configuration software.